Hi,

Working.
I installed on another PC and the programmer switched from update to normal.
When plugged on my PC again it worked.

Thanks,
Abilio

Hi, I have done exactly the same, but the programmer gets stucked on Device Firmware Update (FDU). At the end of the update it doesn't switch to normal operation. I have uninstalled 1.8.5 and install 1.8.4 but the result is the same. The programmer don't switch to normal mode. If you want to have a ...

Hi, I have updated the software and the update finished normally. Now ii reports 1.8.5 software version. Then then software requested a firmware update. I done it, and it seemed to end normally. Powering off and on the programmer doesn't change the status. When I exit software and run it again the f...

Hi,
I got an update message and I proceeded to update
I have a not connected message (picture attached)
It was working with 1.8.4
Regards,
Abilio