Yes it's fine if sensor output range will be at least 10% of input range (10% * 0-30V = 0-3V sensor output). The range will be 0-5V. Will give it a try. Alternatively I can also use a digital sensor. You will need to remove pullup resitor inside the UTCOMP (so you will convert AdcVccX input to AdcX...

Thank you very much for your answer. I hope you had a few quiet and stress-free days. I intend to measure my water temperature as described in this thread: Question regarding temp./pressure sensors . I would like to use input B9 Adc5 for this purpose. Even if the sensor only outputs max 5V. Is that ...

Already found the answer to the EGT question in the forum. GND is not connected.

All I found for the sensors was the statement: Vehicle ground, i.e. A12 or together with it to the body.

The more time passes, the more I want to use UTComp Pro. But I am still preparing well. EGT K-Type Amp: On the IN site: TC1 +/- to probe GND & VCC to 12V board network? Fuse size? Output site: OUT1: Input A8 Adc1! GND OUT: Where do I connect best? Unused B10 "Digital" GND? In general, ...

Thank you very much. I should have read the manual again before I post here.

What type of wire size should be selected for the following sensors: ⋅ Oil and fuel pressure sensor 150 PSI 10 BAR ⋅ Oil and water temperature sensor NTC analogue ⋅ Temperature sensor for UTCOMP ⋅ EGT-K LMP (connection to UTCOMP) ⋅ EGT-K LMP (connect...

Yes, I wanted to do the conversion to Bar. I have only set the raw data here, because I have not ordered my UTComp yet and have not tested the values yet. Thank you very much for your conversion. So far I have unfortunately found different values for the IAT sensor. Here are 2 examples: example2.PNG...

Found out the GM IAT isn't linear.
So I plan to install a second DB in/near the intake manifold.

Thank you very much for the detailed answer. I am sure I will build the system that way. My MAP sensor is an OmniPower 4bar sensor that is linear: 050 kPa = V 0.563 100 kPa = V 1,168 150 kPa = V 1.774 200 kPa = V 2.379 250 kPa = V 2.984 300 kPa = V 3.589 350 kPa = V 4,195 400 kPa = V 4,800 Formula: ...

Hello, I need help selecting my components for UTCOMP. I would like to install a display and read the following information. Logging is nice, but I don't need it urgently. The question, of course, is how many inputs do I need exactly, and of which type? - EGT I'll buy a single-channel amplifier. I a...