Niestety nie, domyślnie wyjście zawsze jest rozłączone. Najlepiej zamienić logikę na wyjściu, tak żeby odłączenie wyjścia (domyślny stan) niczego nie uaktywniało.
1uF will be not sufficient. There are already 100uF/50V on output so you can stay without supercapacitors, it will work, but it in some cases in may restart during cranking when voltage drops below 8V.
Trzeba stosować połączenie (wtyk + gniazdo) dedykowane dla termopary typu K. Chodzi o materiał z jakiego są wykonane blaszki (musi być ten sam co przewody termopary typu K). Na zwykłym połączeniu powstanie błąd pomiarowy.
Hi Frank, Please check the capacitors inside, as they may need replacement after all these years. First and foremost, replace the two goldcaps (supercapacitors functioning as small batteries). These are the green components shown in the picture: Zrzut ekranu 2024-12-04 092745.jpg The current compone...
Przy sprawnych kondensatorach nawet całkowite odłączenie zasilania na 1-2 sekundy nie spowoduje restartu daty. Możesz to przetestować ręcznie odłączając wtyczkę i podłączając po 2 sekundach - data i czas powinny być zachowane. Zacznij od ustawień - nie włączyłeś przypadkiem trybu ultra-energooszczęd...
Both should be the same. Do you have GX2431 in the same package as DS2431? Please show me your connection, typical issue is swaped pin1 with pin3 in TO92 package, so users are connecting pin3 instead of pin1. In REVELPROG-IS when you select DS2431 from database pin4 is ground and pin5 is IO.
Hi rsm, it should work in the same way. I'm connecting to DS2431 just 2 wires (pin4 to I/O and pin5 to GND) and it's working fine. Are you sure that chips are not faulty? Does it still work with your GX2431? Which package do you using? Does programmer pass HW test?