REVELTRONICS

hi
i run into a small issue with the setting of my UTCOMP

i'm going to use 2 OE sensors (powered from ECU) so i will connect them to pins b2 & b3

now my problem is that i want to connect another NTC sensor and use it in pin a20 which will power it but i can't program it in the software

is there any solution for that?

thanks in advance

firmware supports 2x NTC and 4x DS sensors. We will check if possibile to add 3rd ntc sensor but could you use DS instead of NTC?

i already used all of them

please check if it possible to use the 3rd ntc sensor

it will be really helpful


plus, i forgot to mention in the first post
on the input\output chart B7 should be marked as B1 and B0 as B7
mistake or it is intentional?

B7 is DigOutUser
B1 is DigInUser

page 12 http://www.reveltronics.com/downloads/u ... manual.pdf

where did you find this misleading? I think it's mistake if it's different.

you can see the mistake at the picture in the first post

Thanks for pointing this. This mistake is in translation file and we will fix it. Thanks.