REVELTRONICS

Hi,

I want to install a wideband controller.
On the Manual i see there is connection to a wideband controller.

Is there wideband controller you recommend to install? zeitronix, innovate with BOSCH LSU 4.9 sensor etc.......
Calibration needed?

UTCOMP supports all 0-5V controllers and you should connect it to any AdcX input. You will need also to know its output to scale it in utcomp's settings: viewtopic.php?f=28&t=58

Hi,

thanks for reply

The output data i have for the controller is 0 Volt = 7.35 AFR and 5 Volt = 22.39 AFR

Is that enough to introduce in your excel calibration?

yes it is. Just enter in AdcX calculator:

0V -> 7.35 AFR
5V -> 22.39 AFR

and you will get data for UTCOMP:

a = 3,01
b = 7,35