Thank you very much for your answer. I hope you had a few quiet and stress-free days.
I intend to measure my water temperature as described in this thread: Question regarding temp./pressure sensors.
I would like to use input B9 Adc5 for this purpose. Even if the sensor only outputs max 5V. Is that possible the way I imagined it?
Would it also be possible to connect another pressure sensor (fuel this time) to input B8 AdcVcc2 and supply the sensor with power via B10 and B12? Can the pull-up be deactivated or can I ignore it?
Unfortunately I couldn't find any further use for the digital inputs, except temperature sensors. Are digital pressure sensors at all possible/available/... ? Are analog to digital converters a solution, if the input B8 isn't possible to use?
My current connection diagram:
Red = sensors | Green = occupied/used cable
With best regards Timo