Fuel level sensor, resitance / ohm
Posted: Tue Jun 21, 2022 1:04 pm
Hello.
So im starting to get everything in order on my Porsche 944 installing the ucomp 3 pro.
However i am having a little issue on how i can use the oem fuel level sensor.
I connected it to ADC2, then enabled this in the software as an fuel level sensor (pb on)
However how can i calibrate this? as its an resistor signal?
I know the following:
Level Resistance (Ohms)
RESERVE 63.2ohm
1/4 42.2ohm
1/2 21.2ohm
3/4 8.6ohm
FULL (1/1) 2.8ohm
from what i can see in the advance tab, its only voltage adjustment for empty and full.
any ideas on solution?
So im starting to get everything in order on my Porsche 944 installing the ucomp 3 pro.
However i am having a little issue on how i can use the oem fuel level sensor.
I connected it to ADC2, then enabled this in the software as an fuel level sensor (pb on)
However how can i calibrate this? as its an resistor signal?
I know the following:
Level Resistance (Ohms)
RESERVE 63.2ohm
1/4 42.2ohm
1/2 21.2ohm
3/4 8.6ohm
FULL (1/1) 2.8ohm
from what i can see in the advance tab, its only voltage adjustment for empty and full.
any ideas on solution?