REVELTRONICS company will be closed from June 4th to June 14th. Support will be very limited during this time. More details.

Help with DVD RW board

Here you can ask technical questions about REVELPROG-IS and device/memory programming.
chuckbass1
Posts: 1
Joined: Mon May 20, 2024 9:51 pm

Help with DVD RW board

Postby chuckbass1 » Mon May 20, 2024 10:02 pm

Hi,

I am wondering if anyone can give me any pointers on this board, I can not find anything online about this board or chips.

Below is what I have discovered:

The main chip I believe as an MCU by RENESAS with the model R8J32740FP42. Whilst I can find a lot of documents online about RENESAS and other 128 pin chips from them I cannot find anything specific to this one.

The AR15F6 - This seems to be an 8 pin chip, however I was not able to put my 8 pin SOIC clip on it to get a reading, it seems smaller than the usually winbound 8 pin chips I have seen.

The 2ATTI 2ATTI - A8JVG2 - 2050G4 - This one I am confident is correct as I also know it exists in another device for the same purpose and seems to be a motor IC chip commonly found is laser products.

More detailed photos - [Imgur: The magic of the Internet](https://imgur.com/a/jMDrp0V)

The 8 pin chip labelled AR15F6 - Would this be the chip that would program the Renesas chip? I couldn't really find 64 or 128 clip. I did see some Renesas programmers, but I did not find any with the interface to program this chip.

My goal is I would like try and repair this disc drive and take a flash reading as I have done in the past for previous failed hard drives. Any help appreciated, thanks

Return to “Technical Support”

Who is online

Users browsing this forum: No registered users and 2 guests