Bosch Sensor and the Pullup Resistor

Here you can ask technical questions about REVELPROG-IS and device/memory programming.
User avatar
Techpriest
Posts: 4
Joined: Sat May 30, 2020 11:02 pm

Bosch Sensor and the Pullup Resistor

Postby Techpriest » Sun Jun 21, 2020 12:16 am

I cant really figure it out so i better ask,

Iam gonna use the Bosch Pressure Sensor Combined PST-F 1, makes life more easy. But what i cant figure out is the Pullup Resistor
The Sensor Manual says: For temperature measurement please use a pull-up resistor with an optimal value of 4.6 kOhm

Can i do that with the UTCOMP? (PIN A20) or do i have to wire in a Resistor?
wiring2.png
wiring2.png (41.24 KiB) Viewed 1860 times

ArT
Posts: 1497
Joined: Wed Mar 25, 2015 8:54 am
Location: Warsaw, Poland
Has thanked: 51 times
Been thanked: 160 times

Re: Bosch Sensor and the Pullup Resistor

Postby ArT » Sun Jun 21, 2020 9:08 pm

Your connection is incorrect.

In UTCOMP is 1.0kOhm internal pullup resistor on AdcVccX inputs but it should work. Do you connect this temperature sensor only to UTCOMP or is it already powered in vehicle?

In option 1:
temperature signal - just connect it to AdcVccX (A20 or B8)
power (+5V) - pin A6 or pin A18
ground - vehicle ground or any black wire in utcomp
pressure signal - any AdcX (A8, A9, B2, B3..)

In option 2 -
temperature signal - you need to connect it to AdcX because it' already powered from ECU.
pressure signal - any AdcX (A8, A9, B2, B3..)


Return to “Technical Support”

Who is online

Users browsing this forum: No registered users and 13 guests