I tried to read this SOIC8 in circuit, but this failed, so i cut the VCC Line and was able to read the Flash.
After viewing the Binary, I changed some bit and tried to flash again.
Flash failed, Software claims to much power consumption…
So i removed the MX25 from the board and tried again.
Read was „fine“ but strange, writing data was never possible with programmer.
Next I used my Old True Willem GQ-4x and used the same Clip…
Reading took a few minutes longer, but the binary was different.
Is seems that Reveltronics programmer missed some blocks.
So i have two different binaries, Reveltronics and Willem.
Reveltronics does not look ok, Willem is fine.
With Good old GQ-4X I needed to unlock the flash and was able to flash all data with verify fine.
How do I unlock with Reveltronics and how do I flash this chip.
Software complains, that the power is above 200mA and other errors..
I have latest IS software (1.9.0).
Is there something wrong?