EGT sensor wires

Here you can ask technical questions about EGT-K thermocouple amplifiers.
Wolfgangh
Posts: 6
Joined: Tue Aug 24, 2021 8:05 pm

EGT sensor wires

Postby Wolfgangh » Tue Aug 24, 2021 8:12 pm

Hello, I have just received my UTCOMP-PRO plus 4-ch. EGT-K and 2 EGT sensors. I am using this to setup carburators on a 4cylinder twostroke racebike (500cc). I want to know if I can shorten the sensor cables, or at least cut off the cable shoes? Would this change the output signal of the sensor? Also, can I buy the brass olives for the sensor mount alone?

ArT
Posts: 1533
Joined: Wed Mar 25, 2015 8:54 am
Location: Warsaw, Poland
Has thanked: 55 times
Been thanked: 163 times

Re: EGT sensor wires

Postby ArT » Wed Aug 25, 2021 6:17 pm

Yes you can shorten wires, it does not change readings at all. If you would like to extend thermocouple cables than it has to be special thermocouple type k cables.

Brass olivies are available in small set of compression lock:
https://www.reveltronics.com/en/shop/84 ... -84-detail


Return to “EGT-K technical support”

Who is online

Users browsing this forum: No registered users and 1 guest

cron