Page 1 of 1

EGT sensor wires

Posted: Tue Aug 24, 2021 8:12 pm
by Wolfgangh
Hello, I have just received my UTCOMP-PRO plus 4-ch. EGT-K and 2 EGT sensors. I am using this to setup carburators on a 4cylinder twostroke racebike (500cc). I want to know if I can shorten the sensor cables, or at least cut off the cable shoes? Would this change the output signal of the sensor? Also, can I buy the brass olives for the sensor mount alone?

Re: EGT sensor wires

Posted: Wed Aug 25, 2021 6:17 pm
by ArT
Yes you can shorten wires, it does not change readings at all. If you would like to extend thermocouple cables than it has to be special thermocouple type k cables.

Brass olivies are available in small set of compression lock:
https://www.reveltronics.com/en/shop/84 ... -84-detail