temp sensors

[amirtiti]

hi
i run into a small issue with the setting of my UTCOMP

i'm going to use 2 OE sensors (powered from ECU) so i will connect them to pins b2 & b3

now my problem is that i want to connect another NTC sensor and use it in pin a20 which will power it but i can't program it in the software

is there any solution for that?

thanks in advance

[ArT]

firmware supports 2x NTC and 4x DS sensors. We will check if possibile to add 3rd ntc sensor but could you use DS instead of NTC?

[amirtiti]

i already used all of them

please check if it possible to use the 3rd ntc sensor

it will be really helpful


plus, i forgot to mention in the first post
on the input\output chart B7 should be marked as B1 and B0 as B7
mistake or it is intentional?

[ArT]

B7 is DigOutUser
B1 is DigInUser

page 12 http://www.reveltronics.com/downloads/u ... manual.pdf

where did you find this misleading? I think it's mistake if it's different.

[amirtiti]

you can see the mistake at the picture in the first post

[ArT]

Thanks for pointing this. This mistake is in translation file and we will fix it. Thanks.