Good day,
i'm currently wiring my UTComp3 in my '00 Galant V6.
I'm planning on using all stock sensors apart from oilpressure and oiltemp.
Oiltemp -> https://www.ebay.de/itm/323051044742
Oilpressure -> https://www.reveltronics.com/en/shop/60 ... -5v-detail
So, I'm kinda puzzled where to connect which cable.
I guess the oilpressure sensor would need to be connected with the red wire (+5V) to Pin A20 (AdcVcc1 = 0-5V, +5V PULL-UP), black to any GND, green to Pin A8 (Adc1 = 0-5V).
Whereas the temperature sensor als would need one wire connected to Pin A20 (AdcVcc1 = 0-5V, +5V PULL-UP) and on to Pin A9 (Adc2 = 0-5V).
so far correct?
As I'm not using the Pro-Version, I guess I can't implement another sensor?
I'd like to connect the stock engine temp sensor (see attachement) - any chance to do that?
Best regards